Raymarine iTC-5 Installation Instructions Manual page 27

1. Ensure power supply is switched off.
2. Check the selected location for the unit, a clear, flat area is
required, which is safe to have screws fitted to.
3. Offer up the converter against the selected location and mark the
surface through the mounting holes on the converter.
4. Drill 2 holes as marked out above.
5. Secure the screws to the mounting surface, ensuring sufficient
thread remains to allow the converter to be mounted.
6. Mount the converter and slide down to secure in the mounting
holes.
7. Tighten the screws to lock the converter into position.
8. Remove converter cover.
9. Connect required transducer and SeaTalk
Location and mounting
3
1 2
ng cables.
10. Replace converter cover, ensuring that the transducer cables are
placed into the relevant cable guides as shown below
11. Switch on power supply and check system.
Transducer cable guides
1
2
3
Item
1
D12041-1
2
3
4
5
Description
Speed and sea temperature
transducer cable guide.
Wind transducer / Rotavecta cable
guide.
Fluxgate compass cable guide.
Rudder reference transducer cable
guide.
Depth transducer cable guide.
4
5
D12308-1
27