Advertisement
Quick Links
Advertisement
Summary of Contents for Nerdonic Exen Proto
- Page 1 Exen Proto Setup Guide - V1 nerdonic.com...
- Page 2 Setup Guide - Changelog V2 - Added common PC connection and ‘Unknown Device’ fixes nerdonic.com...
- Page 3 Exen Proto - Pinout POWER LED PROGRAMMABLE LED SWD HEADER 13 / PA17 3.3-20V INPUT 3.3 - 20V REGULATED TO 3.3V SOLDER PAD 13 13 / PA17 3.3V INPUT OR RESET 3.3V REGULATED 3.3V OUTPUT SCL / PA23 A0 / PA02...
- Page 4 Exen Proto - Setup If you have not yet downloaded and installed the Arduino IDE to your computer you can download it from the Arduino website here for your OS: https://www.arduino.cc/en/Main/Software It is recommended to download the latest version. In this setup guide we are using version 1.8.1 of the Arduino IDE.
- Page 5 Select the board that says ‘Arduino/Genuino Zero (Native USB Port)’ You are now ready to program the Exen Proto! Connect your Exen Proto via a USB cable to your computer and allow it time to install any needed USB drivers (This should be automatic).
- Page 6 Once you have a sketch ready you need to upload it to the Exen Proto, this can be done 2 ways using USB. 1) This method is if the Exen Proto is powered only by the USB port A) Plug in the Exen Proto to your computer via USB B) Select the port your Exen Proto is connected to in the Tools >...
- Page 7 PC then upload a sketch following the setup guide above. If these fixes dont fix you’r issues please contact Nerdonic nerdonic.com...