Cleaning, Maintenance And Ordering Of Spare Parts - Alpha tools A-SD 3,6 Li Original Operating Instructions

If the battery fails to charge, please check
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts of the charging unit
If the battery still fails to charge, send
•
the charging unit
•
and the screwdriver
to our customer service center.
Timely recharging of the battery will help it serve
you well for a long time. You must recharge the
battery when you notice that the power of the
cordless screwdriver drops.
6.2 ON/OFF changeover switch (Fig. 3/Item 8)
You can select between clockwise and counter-
clockwise rotation.
Change the direction of rotation only when the
equipment is at a standstill. If you fail to observe
this point, the gearing may become damaged.
6.3 LED lamp (Fig. 1/Item 2)
The LED lamp (2) can be used in poor lighting
conditions to illuminate the area where you want
to screw. To switch on, push the switch (3) for-
wards; to switch off , pull the switch back again.
Important!
When the LED lamp is switched on, it will only
light up if the ON/OFF switch is pressed (8).
6.4 Changing the tool (Fig. 5)
Important!
Insert the bit (A) into the bit chuck (1).
To remove the bit (A), pull it back out of the bit
chuck (1).
6.5 Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed
for reliable working. Be sure to use a bit that mat-
ches the screw in shape and size. Set the torque,
as described elsewhere in these operating inst-
ructions, to suit the size of screw.
6.6 Battery capacity indicator (Fig. 4/Item 5)
Remove the cordless screwdriver from the char-
ging unit/charging station.
Press the button for the battery capacity indicator
(6). The battery capacity indicator (5) indicates
the charge state of the battery on 3 colored LEDs.
Anl_A_SD_3_6_Li_SPK7.indb 15 Anl_A_SD_3_6_Li_SPK7.indb 15
GB
All the LEDs are lit:
The battery is fully charged.
The yellow and red LEDs are lit:
The battery has an adequate remaining charge.
Red LED:
The battery is empty, recharge the battery.
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 15 -
26.04.2017 10:42:10 26.04.2017 10:42:10