Advertisement
Subsection XX (COMMUNICATION TOOLS AND B.U.D.S.)
529035697
OPTIONAL MALE-FEMALE EXTENSION SERIAL CABLE
4. Connect the
MPI-2 INTERFACE CARD (P/N 529
to the USB port of a PC (personal
036 018)
computer).
vdd2006-001-151
mmr2006-079-200
MPI-2 INTERFACE CARD CONNECTED TO USB PORT
CAUTION If the computer you are using is
connected to a power outlet, there is a poten-
tial risk of electric shock when working in con-
tact with water. Be careful not to touch water
while working with the computer.
5. Use B.U.D.S. software as described further in
B.U.D.S. SOFTWARE
B.U.D.S. SOFTWARE
B.U.D.S. (BRP Utility and Diagnostic Software)
is designed to allow programming key(s) to the
vehicle, allow electrical and electronic component
4
.
monitoring, activation of certain components for
diagnostic purposes, and to carry out settings
changes.
Always use the latest applicable B.U.D.S. version
available on BOSSWeb.
How to Read the Electronic Control
Units Using B.U.D.S. Software
IMPORTANT: Ensure all connections have been
made before starting B.U.D.S. to allow proper
MPI-2
operation. Refer to
1. Press the START button to wake up the electri-
cal system.
2. Install the tether cord on the engine cut-off
switch.
3. Start B.U.D.S. and logon.
NOTE: B.U.D.S. will automatically choose the ap-
propriate MPI 2 protocol.
4. Ensure the appropriate number of modules is
shown in the status bar.
NUMBER OF
MODULES
2
ECM and multifunction gauge
tmr2011-019-002_b
STATUS BAR
1. Number of modules read by B.U.D.S.
5. Read electronic modules by clicking the Read
Data button.
vmr2006-012-100_aen
B.U.D.S. is now ready to use.
in this subsection.
MODULES
smr2014-026
Advertisement
