Advertisement
Installation Instruction
Unpacking the appliance
Before use, remove all packing materials, including bottom cushions, foam pads and tapes inside of the
refrigerator; tear off the protective film on the doors and the refrigerator body.
Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or watery places to prevent
rust or reduction of insulating effect.
Do not spray or wash the refrigerator; do not put the refrigerator in moist places easy to be splashed with
water so as not to affect the electrical insulation properties of the refrigerator.
The refrigerator is placed in a well-ventilated indoor place; the ground shall be flat, and sturdy.
Electrical and product Details
Rated Voltage/Frequency
Rated Defrost Power
Rated Current
Rated Defrost Power
Refrigerant
Insulation Blow Gas
Product Dimensions WxDxH
Net Weight
Location
When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well ventilated.
Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight as it may increase
the electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. This
unit is not designed for use in a garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, ensure that 10cmof free space is left at both sides, 10cm at the rear and 30 cm at the top of
the unit. This will allow cold air to circulate around the wine cooler and improve the efficiency of the cooling process.
220~240V/50Hz
220 W（230V）
0.8 A
220 W
R600a
Cyclopentane
700x666x1880mm
87Kg
6
Advertisement
