Advertisement
RFID Wall Reader Instructions - (Surface Mount)
2
7
FIGURE 1
Instructions
1. Pull cable(s) for RAC through hole in the back plate and, if applicable, through the gasket then screw the mounting plate of
the reader to the wall using the screws provided. Use the 1 1/4" wood screws and inserts for drywall, or use the 1/2" steel
screws for mouting on a metal frame
2. Adhere the round gasket (in hardware bag) to the back plate (item #4) with the cutout located so the gasket does not cover
the screw (item #7) as shown in Figure 1, if not installed
3. Connect cables for ILCO RAC 4 or RAC 4XT as per page 3 of this document
4. Connect ble cable to ble connector (figure 3)
5. Hook the top of the reader enclosure (item #2) onto the top of the mounting plate (item #4) and secure together with the
included screw (item #1), tightened at the bottom of the reader
4
3
BLE MODEL SHOWN
MOUNTING SCREW
4
6
HOLES
1
RFID Wall Reader Installed with ILCO RAC 4 or RAC4XT Installation Guide - PK3660_07_16
2
6
FIGURE 2
2
BLE CONNECTOR
FIGURE 3
4
BLE MODEL SHOWN
Advertisement
