Download Print this page

Kaba R79K-1G Series Installation Manual page 3

Rfid wall reader installed with ilco rac 4 or rac4xt

Advertisement

RFID Wall Reader Instructions - (All Models)
Figure A: RFID Wall Mounted Reader
Instructions
1. Use drilling template provided to prepare surface for installation
2. Route the wire to the rac 4/4xt enclosure and connect to the controller board as per the column "RAC 4/4XT Controller
Board Connection" in table 1, or as per Figure B
3. Route the other end of the wire through the hole in the mouting plate to the back of the reader and connect as per column
"Reader Connection" in table 1 or as per Figure A
Signal
Reader Connection
GND
+12V
RS485+
RS485-
Note: Jumper cables as shown in figure B must be connected for the reader to operate correctly.
Table 1: RAC 4/4XT RFID Wall Mounted Reader Wire Connections
Important: The jumper cables supplied with the reader must be connected as shown in Figure B and Table 1 for the contactless
reader to operate properly.
Note: The RAC 4 controller board supports a single reader only, for ingress functionality, using connectors J1 and J2.
Note: The rac 4XT controller board can support dual readers for ingress (Connectors J1 & J2) and egress (Connectors J13 &
J14) functionality.
3
BLUETOOTH (BLE)
CONNECTOR
Controller Board to RFID Wall Mounted Reader Connection
RAC4/4XT Controller Board Connection
Terminal Block
Ingress Reader
J4 - 2
J4 - 1
J5 - 2
J2, Pin 1 + J3, Pin 1*
J5 - 1
J2, Pin 2 + J3, Pin 2*
For INGRESS
Application
For EGRESS
Application
Figure B: RAC 4XT Controller Board
(Note: RAC 4 Ingress only)
Egress Reader
J1, Pin 2
J14, Pin 2
J1, Pin 3
J14, Pin 3
J13, Pin 1 + J12, Pin 1
J13, Pin 2 + J12, Pin 2
RFID Wall Reader Installed with ILCO RAC 4 or RAC4XT Installation Guide - PK3660_07_16
See Note 1*
1 2 3 1 2 3
1 2 3 4
J1
J2
J3
J19
Bypass
SW3
Active
J18
Controller
ON
Board
J17
124-511689-002
J16
J15
J14
J13
J12
1 2 3
1 2 3 1 2 3 4
Wire Color
Comments
Black
Red
White
See Note
Green
See Note
Programming
J5
Port
Reset
J6
SW1
SW2
J7
J8
J9
GND
+12V

Advertisement

loading

This manual is also suitable for:

R79k-1n seriesR79k-1sx2 seriesR79k-1fx2 series