ADJUSTING THE REAR BRAKE
The rear brake is disk type with mechanical
control for which requires periodic adjustment
interventions.
The clearance on the rear brake lever should be 5
to 6 mm.
The adjustment must be performed as follows:
-In the driving position to verify the clearance
-if the stroke was superior turn register A on the
brake lever
Attention: After each adjustment, tighten the
locknut.
For the adjustment of the tension of the brake
cable to act on the bolt B so that operating the
lever on the handlebar braking is immediate, and
that the wheel rotates freely when the lever is not
operated.
37