Installation; Unpacking And Checking The Unit; Finding The Best Location; Initial Setup - Sprint Magic Box TREBL Design Requirements Document

IPv6 Support Yes
Peak UE DL DL=B41/580 Mbit/s , 4CA 256QAM
Throughput
DL Transmission
DL Transmission Mode 1 -9
Mode
Frame Type 1 FDD
Frame Type
Frame Type 2 TDD, 5ms periodicity
B41: 4T8R
Tx/Rx
B25: 2T8R
DeNB Selection and Ranking
Scanning
PDCL --> Donor Selection Algorithm

4. Installation

The Sprint TREBL unit is placed on the windowsill to receive the signal from outdoors and boost it
indoors. The following steps instruct on the proper positioning and setup of the Sprint Magic Box
unit for optimal service.

4.1 Unpacking and Checking the unit


Carefully unpack the Sprint TREBL unit from the box.

Inspect the unit for any damage and check that all the accessories are in the box.

Remove the Power Supply (included) from the packaging.

4.2 Finding the Best Location

Choose an appropriate window at the suitable side of a building is vital to get the best performance

The Sprint TREBL has a built-in capability to survey the 4G signal from suitable provider cell
towers & also use GPS to accurately determine its location. It can do this for multiple windows
in the same or on multiple floors, ideally in all four directions of the building.

Connect the power supply to the underside of the AU 587 and place it at the 1st window
(ideally in the middle of the window).

Wait for the RF survey to complete

Go to the next window and repeat the survey process

Test as many windows as possible in all four directions as possible

Once you finish testing all locations, select the best location out of all surveyed locations and
press "Install Here" in the location

Initial Setup

4.3
B25/600 Mbit/s (3CA 256QAM)
Page 10