Husqvarna 340i Operator's Manual page 17

CAUTION: Make sure that the battery is
installed correctly into the battery holder.
If the battery does not move easily into
the battery holder, the position is not
correct.
4. Push on the lower part of the battery until you hear a
click sound.
5. Push and hold the start/stop button until the green
LED comes on.
To use the SavE function
The SavE function decreases the chain speed and the
power of the product.
1. Push the SavE button. The green LED comes on.
2. Push the SavE button again to disconnect the
function. The green LED goes off.
To stop the product
1. Push and hold the start/stop button until the green
LED light goes off.
1155 - 002 - 13.05.2020
2. Push the battery release buttons and remove the
battery from the battery holder to prevent accidental
start.
Pull stroke and push stroke
You can cut through wood with the product in 2 different
positions.
• To cut on the pull stroke is when you cut with the
bottom of the guide bar. The saw chain pulls through
the tree when you cut. In this position you have
better control of the product and the position of the
kickback zone.
• To cut on the push stroke is when you cut with the
top of the guide bar. The saw chain pushes the
product in the direction of the operator.
WARNING: If the saw chain is caught in
the trunk, the product can be pushed at
you. Hold the product tightly and make
sure that the kickback zone of the guide
17