Assembly - Husqvarna 340i Operator's Manual

To assemble the guide bar and saw
chain (with bar knob)
WARNING: Always remove the battery
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the bar knob.
3. Remove the drive sprocket cover and the
transportation ring (A).
4. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
1155 - 002 - 13.05.2020

Assembly

5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
7. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
8. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
9. Apply tension to the saw chain. Refer to
Maintenance on page 24 for instructions.
10. Tighten the bar knob.
To assemble the guide bar and saw
chain (with bar bolt)
1. Disengage the chain brake.
A
WARNING: Always remove the battery
before you assemble or do maintenance on
the product.
13