Sony Vaio VGC-RC Series Service Manual page 11

1
FLOWCHART
FLOWCHART
2
1
grease
(in the surface
at the splatter)
2
4
3
4 CPU
Note : When heat sink is removed from CPU, install new ones
after thermal diffusion grease is wiped off and silicon
compound is applied to the place shown in the figure.
Thermal diffusion grease : silicon compound (G-765) 90G
Amount to apply : 0.5 g (as the same size as the tip of a match) (Pentium 4)
* Take care not to apply the grease to any other places because it has high conductivity.
1-8
5 MDC Modem Unit
3
MDC MODEM UNIT
1 Remove a connector (power).
2 Remove a connector
(Azalia Harness).
3 Remove a connector
(RJ11 Harness).
4 Remove
a screw.
5 Remove the MDC Modem Unit
in the direction of arrow.
CPU
1 Lay the set down sideways.
2 Remove the lever.
3 Open the cover.
4 Remove the CPU vertically.
Sony Confidential
VGC-RC Series (AM)
B2