Subscribe to Our Youtube Channel
Related Manuals for KAMA-LABS NUMITRON v5
Summary of Contents for KAMA-LABS NUMITRON v5
- Page 1 WWW.KAMA-LABS.COM ASSEMBLY MANUAL NUMITRON IV-9 CLOCK If you will have any questions, contact with me here: info@kama-labs.com GOOD LUCK!
- Page 2 1) You have a PCB with ICs: 2) Place all resistors vertical:...
- Page 3 3) Place photoresistor. Make height of photoresistor equal buttons height.
- Page 4 4) Place net.resistors: Common pin to square pad.
- Page 5 5) Place all capacitors. Be careful with polarity!
- Page 6 For ceramic capacitors polarity is not matter. 6) Place all transistors and IC10 according marking on PCB:...
- Page 7 IC11 – temperature sensor and should place on BOTTOM side of PCB:...
- Page 9 7) Buttons: 8) Install buzzer:...
- Page 10 9) Place battery holder and insert battery when clock will be fully assembled:...
- Page 11 Place sockets for ICs. Insert KR514ID2 chips at the end of assembling process: Install Infrared receiver:...
- Page 12 Insert 6 RGB LEDs...
- Page 14 Prepare and install AUTO leds. This LEDs should be installed on BOTTOM side of PCB:...
- Page 16 Install power plug: After all, your clock should looks like on photo:...
- Page 18 Prepare and install all IV-9 tubes. You can see that pins of tubes cuts spiral already. The longest pin – first pin:...
- Page 19 Place 2 separator tubes. Plus and minus – no matter:...
- Page 20 Install tube drivers KR514ID2: Now, your clock should looks like this:...
- Page 22 After all clock should work.
- Page 23 Assembling of plastic case. Firstly, take bottom panel in hand and put clock above.
- Page 24 Then insert back, front and side panels: At last, insert top panel and tighten the nuts.
- Page 25 CONGRATULATIONS!
-
Page 26: Specification
SPECIFICATION Please note, that elements in kit can be a little different. If you doubt value of element, check it with multimeter. IF VALUE OF ELEMENT IN SPECIFICATION AND ON PCB IS DEFFERENT, PLEASE USE VALUES FROM SPECIFICATION AND SCHEMATIC. Label Value Photo... - Page 27 C4, C5, C7 0.1u D1, D2, D3 LED Auto D4-D9 RGB Leds IC1-IC6 KR514ID2 STM32F100C8T DS32kHz...
- Page 28 IC9, IC11 AMS1117-3.3 IC10 DS18B20-PAR IR-sensor SF2-1 R1, R7, R10, R12, R15, 1.2k R2, R3, R6 R4, R8...
- Page 29 R9, R11, R14 330 рез. Сборка R13, R18 9.1k 4.3k S1,S2,S3 Buttons T1, T2, T3, IV-9 T4, T5, T6 T7, T8 LAMP раздел.
- Page 30 VT1-VT7 USB-micro Power plug CR1220 battery holder...
- Page 31 Plastic case 5V Power adapter USB-UART converter Sockets 14pin...
Need help?
Do you have a question about the NUMITRON v5 and is the answer not in the manual?
Questions and answers