Advertisement
MANUAL for JAKKA PRO CONTROLLER
12. MOUNTING INFORMATION
1) Use standart junction box.
Hole distance must be 60mm
center to center.
Use 68mm hole saw.
13. CONTROL PANEL CABLE CONNECTIONS
2) Remove the
3) Secure the
front panel
rear panel by
using a thin-
screwing screws.
blade flat
Necessary
screwdriver.
screws are in the
box.
(2 x 2 x 0,34...0,75mm²)
Shielded, Twisted Pair, RS485 Data Com-
munication Cable must be used.
4) Make the
5) Attach the clip
cable connecti-
at the top first,
ons as shown
and then attach
below to termi-
the clip at the
nals on the front
bottom.
panel.
Note : Press the terminal buttons with
the help of a fine-tipped pen as shown
in the figure. Don't apply extreme
pressure.
NOTE: DON'T USE THE SCREWDRIVER
Advertisement
