Download Print this page

Sunbeam 2372 Instruction Manual page 4

Hand/stand mixer
Hide thumbs Also See for 2372:

Advertisement

Available languages

Available languages

B
EATERS
The open beater design allows for thorough, fast mixing results for all types of batters
and easy clean up. The beaters are dishwasher safe.
The handle has been designed for comfort to prevent fatigue of the hand during heavy or long
mixing tasks.
U
Y
SING
OUR
Before using your mixer for the first time, wash the beaters in hot, soapy water or in the
dishwasher. Rinse and dry.
Be sure speed control is in the "OFF" or "0" position and unplugged from an electrical outlet.
Insert beaters one at a time, by placing stem end of beaters into the opening on the bottom of
the mixer. Turn beater slightly and push in until beater clicks into position. Plug cord into
appropriate outlet.
Although your mixer is much more convenient to use on a stand, it is not designed to be used
for heavy mixing, or in recipes calling for more than 3-l/2 cups of flour. This may cause
overheating and possibly motor damage.
Slowly guide mixer around sides and through center of bowl, going in the same direction
Be careful not to overbeat the mixture. Overbeating tends to make some mixtures tough.
Whenever scraping of the bowl is required, stop the mixer and scrape sides and bottom of
bowl with a rubber spatula as needed. Turn speed control to "OFF" or "0" and rest mixer
on its heel rest while adding ingredients. Be sure to position beaters over mixing bowl
so any drippings will fall back into mixing bowl.
When mixing is complete, set speed control to "1" and raise beaters slowly from batter
to clean off clinging food. Be sure to turn unit to "0" before raising beaters completely
out of mixing bowl.
Ingredients should be added to the mixing bowl exactly as they are specified in the recipe.
When combining wet and dry ingredients, you may wish to moisten ingredients on low speed,
then turn to the desired speed as specified in the mixing guide.
H
AND
To attach the Hand Mixer to the Stand, tilt the Stand's Cradle (the top of the Stand that hold.
the Mixer) back and insert the Mixers two slots (located in the bottom center of the Mixer)
over the Cradle's protruding tabs. Then push the Mixer until the Stand's locking tabs snap
into the Mixer.

Advertisement

loading