NETGEAR C3000 Manual

Hide thumbs Also See for C3000:

Installing the Gateway

1. Check that a coaxial cable is already connected to a cable wall outlet or RF splitter (optional).

2. Connect the other end of the coaxial cable to the Cable connector on the C3000.

Use your hand to tighten the connectors to avoid damaging them.

3. Connect the Ethernet cable to an available Ethernet port on the C3000.

4. Connect the other end of the Ethernet cable to the Ethernet port on your computer.

Optional: Repeat steps 3 and 4 for an additional computer or other network device that you

want to install as a wired connection on your home network.

5. Connect the power cord to the Power port on the C3000.

6. Plug the other end of the power cord into an electrical wall outlet.

Although your computer may already be configured to automatically access the Internet, you should

still perform the following gateway connectivity test to verify that the devices were connected properly.

1. Power ON the computer connected to the C3000 if it is turned off, and then log in.

2. Contact ATMC to activate (provision) the C3000. You may have to provide the HFC MAC ID

listed on the

3. After the C3000 is activated, open a web browser (Internet Explorer, Google Chrome, Firefox,

or Safari) on your computer.

gateway

label.

Table of Contents

Do you have a question about the C3000 and is the answer not in the manual?

Page 1 1. Power ON the computer connected to the C3000 if it is turned off, and then log in. 2. Contact ATMC to activate (provision) the C3000. You may have to provide the HFC MAC ID...
Page 2 4. Check that the Power, Receive, Send, and Online front panel LEDs on the C3000 light up in sequential order. See Front Panel for additional LED status information. ο If all four LEDs did not light up solid and you also do not have an Internet connection, you may have...