Table of Contents
Advertisement
ENGLISH
8
4
The small nozzle can be used for vacuum cleaning small areas, e.g. the seats of chairs and
sofas (fig. 12).
Vacuum cleaning
1
Pull the cord out of the appliance and put the mains plug in the wall socket (fig. 13).
2
Switch the appliance on by pushing the on/off button on top of the appliance with your foot
(fig. 14).
3
To carry the appliance, put the handle in upright position and lift the appliance by the handle
(fig. 15).
Adjusting suction power
You can adjust the suction power during vacuum cleaning:
1
Adjust the suction power by means of the electronic suction power control (specific types
only) (fig. 16).
Infrared remote control (specific types only)
1
Place the batteries in the battery compartment (fig. 17).
Make sure the - and + poles are pointing in the right direction.
2
With the infrared remote control you can set the suction power to one of 5 different suction
power settings.When you switch the appliance on, it will always start running at the highest
suction power setting.
3
By pushing the - button, you will reduce the suction power by one setting (fig. 18).
4
By pushing the + button, you will increase the suction power by one setting.
5
Push the standby button to temporarily switch the vacuum cleaner off, for instance when you
have to move some furniture.
6
To continue vacuum cleaning, simply press the - button or the + button.The appliance will
start operating at the previously selected suction power setting again.
Storage
1
Switch the appliance off.
2
Remove the mains plug from the wall socket.
3
Rewind the mains cord by pressing the cord rewind button (fig. 19).
4
Put the appliance in upright position and attach the lower tube to the appliance by means of
the clip (fig. 20).
The height of the clip can be adjusted by sliding it along the tube.
Replacing the dustbag
Replace the dustbag as soon as the "dustbag-full indicator" changes colour (when the nozzle
is not placed on the floor).
1
Switch the appliance off.
2
Open the cover (fig. 21).
3
Push the dustbag holder backwards (fig. 22).
Advertisement
Table of Contents
