Samsung HW-S60T Full Manual page 21

3. Press and hold the Up button on the Soundbar remote control for 5 seconds or press the ID SET
button on the bottom of the Soundbar.
• Until pairing is complete, the Multicolor LED changes as Red → Green → Blue in turn.
Rear Speaker, Woofer Pairing button
5 Sec
4. Check if the LINK LED is solid blue (connection complete).
Front of the Wireless Subwoofer
NOTES
– Do not connect the power cord of this product or your TV to a wall outlet until all connections
between components are complete.
– Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
– The maximum transmission distance of the wireless signal of the main unit is about 32.8 ft (10 m),
but may vary depending on your operating environment. If a steel-concrete or metallic wall is
between the main unit and the wireless subwoofer, the system may not operate at all, because the
wireless signal cannot penetrate metal.
PRECAUTIONS
– Wireless receiving antennas are built into the wireless subwoofer. Keep the units away from water
and moisture.
– For optimal listening performance, make sure that the area around the wireless subwoofer and
Wireless Receiver Module (Sold separately) is clear of any obstructions.
ID SET NETWORK
OR
ID SET NETWORK
Bottom of the Soundbar
Main Unit
SERVICE
ID SET NETWORK
SERVICE
Stops blinking.
Glows blue.
DIGITAL AUDIO IN HDMI
(OPTICAL) (ARC)
ID SET NETWORK
SERVICE DC 19V
DIGITAL AUDIO IN
(OPTICAL)
SERVICE DC 19V
DIGITAL AUDIO IN
(OPTICAL)
SERVICE DC 19V
DIGITAL AUDIO IN HDMI
(OPTICAL) (ARC)
SERVICE DC 19V
DIGITAL AUDIO IN HDMI OUT
(OPTICAL) (TV-ARC)
DC 19V
DIGITAL AUDIO IN HDMI
(OPTICAL) (ARC)
DC 19V
The LINK LED indicator stops blinking
and glows a solid blue when a
connection is established between the
Soundbar and the Wireless Subwoofer.
ENG - 21
LED Indicator
HDMI OUT
(TV-ARC)
→ →
Red Green Blue Blinks
HDMI
(ARC)
DIGITAL AUDIO IN
(OPTICAL)
Pairing
Cyan Blinks X3
Connection is complete
DIGITAL AUDIO IN
(OPTICAL)