Nakanishi AL-0203 Operation Manual

Air Line Kit
AL-0203
Thank you for purchasing Air Line Kit （ AL-0203） .
This device is designed for E800Z standard set. It provides Control Unit with clean air flow as
well as SPINDLE （NR-3080） with oil mist. Read the operation manual carefully before initial use.
1 CAUTIONS IN HANDLING
⁄ Read these cautions carefully to correctly follow the intended use.
¤ Safety instructions are intended to avoid potential hazards that could result in personal
injuries or damages to the device.
Safety instructions are classified as follows in accordance with the seriousness of the risk.
Class
Existence of a hazard that could result in bodily injury or damage of the device,
WARNING if the safety instructions are not followed.
Possibility of a hazard that could result in light or middle degree of bodily injury
CAUTION
or damage of device, if the safety instructions are not followed.
WARNING
⁄ Air Pressure
Use the air pressure below 1.0MPa on primary side and 0.6MPa on secondary side.
¤ Use of Clean Air
Air shall be clean and free from chemicals, compound oil containing organic solvent,
salinity, or corrosive gas to avoid damage to the device.
‹ Connection of Hose
Connect hose securely to avoid accidental disconnection during use. Do not exceed
1.0MPa for air hose pressure. Make sure that the pressure from the air compressor
does not exceed 1.0MPa. If the pressure exceeds 1.0MPa, hose might burst.
WARNING
An experienced and well-informed person shall assemble, operate and service the
air compressor.
CAUTION
⁄ Use of dry air
Use of air with excessive moisture could result in malfunction or failure of air tools. In
case large moisture condensation is often found at the air filter of this air line kit, it is
recommended to install a larger air filter or air dryer before the primary side of the air
line kit.
¤ Draining
Be sure to drain moisture condensation from Filter regularly to avoid moisture
carried by air to the air tool.
‹ Installation Location
Place this device on a flat surface. When placing it on the wall, check if the wall is
flat. Hang it horizontally.
› Handling
Care should be exercised and avoid breaking Plastic Bowl of Filter when it is
removed for cleaning.
OM-K0288E Rev.A
Degree of Risk
CAUTION
¤ Do not use the device where corrosive gas, chemicals, seawater, water, or steam
exists.
¤ Do not use in the direct sunlight.
‹ Do not use where the device is subject to vibration or repetitive shocks.
› Do not use where heat source or radiant heat exists.
2
FEATURES
⁄ The device can provide Control Unit with clean air as well as Spindle （NR-3080）with oil mist.
¤ It eliminates dirt and debris, as the air passes Filter.
‹ Air pressure can be adjusted easily.
› Mist lubricator could extend air tool life.
fi The device can be mounted on the wall.
3 SPECIFICATIONS
Primary air pressure 1.0ＭPa Max.
0.6Ｍ Ｐa
Maximum Operating Pressure
1.5Ｍ Ｐa
Withstanding Pressure
5-65℃ （41-149° F）
Operating Temperature Range
0.3μm
Filtration Rating
0.04-0.6ＭPa
Set Pressure
ACCESSORIES
・2m Hose ・ 4 Rubber padding, 4 Screws, 4 Washers ・Lubricant （70 cc）・Operation Manual
※Lubricant
Liquid paraffin, ISO VG15 is recommended.
4
COMPONENT NAMES
Regulator
Filter
Hose
Relief Pressure Set Pressure plus 0.05MPa
Lubricant Used ISO VG15, Liquid Paraffin, or equivalent.
Bowl Capacity 65 cc （approx. 4 cu-in）
Dimensions W300 × D120 × H220 mm
Weight 3.7Kg
Pressure Gauge
ON-OFF Valve
ＵＮＩＴ
ON-OFF Valve
ＳＰＩＮＤＬＥ
Lubricator
Fig.1