Advertisement
At the end cover the complete connector
including resistor with another heat shrink
tube.
Trial fit the ESC. Reinstall the duct, route
the motor cables out of the duct and
connect them to your ESC.
Install the Fan and exhaust duct in the
plane and mark the position of the ESC
under the thrust tube (see next pictures).
Remove the duct and ESC and mark the fin
position. Cut slits into the duct to allow the
fins to pass through. Also cut the opening
for the Motor wires.
To get enough distance between
ESC/Motor and receiver, we installed the
ESC directly behind the fan on top of the
thrust tube. Slide it into the fuselage
slightly. This will keep the ESC in place
(together with the wing which will later rest
on it).
Page 30/34
Advertisement
