Table of Contents
Advertisement
2610051914.qxp_GCM18V-08 6/24/19 1:56 PM Page 44
▶ Special Cuts
operation. Before switching on, lower head
assembly to make sure clamp clears guard and
head assembly.
with the saw Off by conducting a simulated
cutting cycle, and observe the projected path of
the saw blade. Keep hands at least six (6) inches
away from the projected path of the saw blade.
hand to saw blade, extend the sliding fence and
base extensions when making extreme bevel,
miter or compound cuts.
▼ CUTTING BOWED MATERIAL
▼ CUTTING ROUND OR IRREGULARLY SHAPED
MATERIAL
Saw Operations
Use clamping position that
does
not
interfere
with
Be aware of the path of the
saw blade. Make a dry run
To
provide
sufficient
(minimum 6") spacing from
Fig. 49
Clamp
Sliding
Fence
Fig. 50
Clamp
Sliding
Fence
44
No Gap at
this Point
Bowed
Material
Round
Material
Advertisement
Chapters
Table of Contents
