Additional Safety Rules - Bosch CM8S Operating/Safety Instructions Manual

2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 6
Safety instructions for miter saws
guarding system.
Provide adequate
extensions, saw horses, etc. for a workpiece that
is wider or longer than the table top.
Do not use another person as a substitute for a
table extension or as additional support.
The cut-off piece must not be jammed or pressed
by any means against the spinning saw blade.
Always use a clamp or a fixture designed to
properly support round material such as rods or
tubing.
▶ Double-Insulated Tools
support such as table

Additional Safety Rules

SAVE THESE INSTRUCTIONS
Let the blade reach full speed before contacting
the workpiece.
If the workpiece or blade becomes jammed, turn
the miter saw off. Wait for all moving parts to stop
and disconnect the plug from the power source
and/or remove the battery pack. Then work to free
the jammed material.
After finishing the cut, release the switch, hold the
saw head down and wait for the blade to stop
before removing the cut-off piece.
Hold the handle firmly when making an incomplete
cut or when releasing the switch before the saw
head is completely in the down position.
Avoid overheating saw blade tips.
6