Table of Contents
Advertisement
Controls
Lights up when the effect is engaged.
09 - LED
Turns on/off the effect. The true bypass switch allows your
10 - TRUE BYPASS
sound to remain intact when the effect is off.
Optical switch for the functions:
11 - TAP TEMPO
• Tap Tempo: Controls the delay time by means of taping in the switch. To use it,
simply tap on the switch between three and eight times, at the desired speed. The
resulting tempo is the average between the taps, and will remain until a new tempo
is set by either tapping or turning the TIME knob.
• Tap Feedback: Holding down for one second it enables/disables the feedback in-
crease. It allows to increase the repeats above of the Repeats setting by using your
foot. Feedback here is taken from the second chip output and is independent on
the setting of Level controls, so it can achieve some different sounds in particular
when using the special subdivisions. Indicator led will change to Green color when
the feedback is activated.
• Tap Div: Holding down for five seconds it gives access to the DIV control setting
(see item 4). Indicator led stops blinking and changes to Orange color.
Tempo and mode change indicador. Blinks at the current delay time set-
12 - LED
ting and its color indicates the mode in use.
Order in the effects chain
Technical specifications
Model 2016 - MDT-6
True Bypass
Input impedance: 700Kohm
Power supply: DC 9v center negative (minimum 100mA)
Power consumption: 80mA at 9v DC
Dimensions: 12cm x 9.4cm x 5.4cm
Weight: 475gr
Trimpots:
RV2: Input Trim: Input level to the delay circuit
RV3: Feedback: Maximum feedback
Advertisement
Table of Contents
