Page 1
™ For The ON-THE-GO Pet INSTRUCTION MANUAL ROADSTER Pet Stroller PG8600 Interior Dimensions: 33L x 20W x 21H To see our full line of products, visit us online at: www.petgearinc.com CUSTOMER SERVICE HELP DESK customerservice@petgearinc.com Toll-Free 877-752-9123 - Eastern Standard Time 8am-3pm, Monday through Friday...
Not intended to be used as a restraining device for aggressive or dangerous animals that dig, chew or paw aggressively. Do not leave your pet unattended. PET GEAR is not liable for any damage caused by aggressive, destructive, immature or untrained animals. Do not use near an open or exposed flame.
Page 3
BACK WHEEL ASSEMBLY Inside Outside 1. Slide back wheel on axle as shown in Figure B. Push in axel until it clicks. Pull on wheel to make sure the wheel is engaged. Repeat on other side. When finished it should look like Figure C. Figure A Lock/Release Button Note: To remove wheel, push the lock/release button...
Page 4
BACK WHEEL ASSEMBLY AND INSTRUCTIONS 2. Take rear wheels (on axel with brakes) and 3. Place stroller so wheels are on the ground and back wheels are facing you (shown in Figure E). lock them into the 2" posts by placing leg tube over the posts and pressing down until they click (shown in Figure D).
Page 5
FRONT WHEEL ASSEMBLY AND INSTRUCTIONS 6. To attach front wheel, slide plastic wheel 7. Slide wheel up, until velco pins pop out of holes. support up and into tubing. Tubing Velco Pin Tubing Velco Pin 8. To use stroller in locked position for jogging, 9.
Page 6
TO FOLD/PACK UP STROLLER 1. Remove handlebar, by pushing velco pins 2. Pull support bar up to release and continue to in to release. Pull handlebar up and off. swing the bar counter-clockwise. 3. Fold sides inward, until flat, as shown below. PG8600 ROADSTER Pet Stroller...
• NOTE: Do not lubricate brake components or swivel locks. REPLACEMENT PARTS Please have your model number ready before calling. Use only PET GEAR replacement parts. PO Box 99 West Rutland, VT 05777 877-752-9123 www.petgearinc.com...