1. Manuals
  2. Brands
  3. BARRON Manuals
  4. Light Fixture
  5. TRACE-LITE AXB
  6. Installation instructions

BARRON TRACE-LITE AXB Installation Instructions

Hide thumbs
1
2
3

Advertisement

Table of Contents

AXB
Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations
if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
20070157 REV 1 P-3 12/19

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!
Technical Support
■ (623) 580-8943 ■ technicalsupport@barronltg.com
1
800-533-3948 www.barronltg.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TRACE-LITE AXB and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for BARRON TRACE-LITE AXB

Summary of Contents for BARRON TRACE-LITE AXB

  • Page 1 Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
  • Page 2 Installation Instructions 1. Insert anchor bolts in concrete with approximately 2” of exposed Fig. 1 threads in a 2” x 2” square pattern (Fig. 1 & 2) use base plate template for alignment (see page 3 of instructions). 2. Run the electrical wires (4ft minimum) through bollard base. 3.
  • Page 3 Installation Instructions Wiring Connections Wire Diagram Make electrical connections per Wiring Diagram. Black Line If dimming is not used. Separate the purple and gray wires and cap White Common individually. Green/Yellow Green Ground This fixture auto adjusts for voltages between 120VAC-277VAC. Purple a.

Table of Contents