Troubleshooting - Inalsa Micro WD10 Instruction Manual And Warranty Card

Trouble Shooting
Problem
The appliance does not
switch ON
The appliance has weak
suction power
The dust escapes from
the appliance
The hose or brushes do
not pick up
Heat produced during
use
Cause
Power cord not firmly
plugged into socket.
No power in the main
Supply
Dust bag is full
Unit clogged
Dust bag needs cleaning
Dust bag is full
Dust bag is not installed
correctly.
Puncture/Hole in dust bag Replace dust bag
Hose clogged
Dust bag is full
A small amount of heat is normally produced by the
vacuum cleaner due to high motor RPM.
9
Corrective Action
Plug in the unit firmly
Take it to the authorized service
center.
Empty dust bag.
Turn unit off and unplug from
wall socket. Remove dust bag
and check for objects in air duct
and remove.
Clean or replace dust bag
Empty dust bag
Review dust bag instruction
Remove hose and/or brushes
Remove obstruction from hose.
Empty and clean dust bag