Emptying Collection Tanks And Bags - Graco LazerVac 550 25M860 Operation - Repair - Parts

Emptying Collection Tanks and
Bags
DUST HAZARD
Grinding concrete and other surfaces can create dust
that contains hazardous substances. To reduce the
risk of serious injury:
• Respirator must be worn when emptying or
cleaning Dust Collection Tanks or bags.
• Follow local ordinances and regulations for
disposal.
Cyclone Separator
1. When Dust Collection Tank is full, turn off vacuum.
Wearing a respirator, remove the Separator Lid and
the Dust Bag Holder from the tank.
2. Gather and secure the top of the collection bag. Lift
and remove the collection bag, tie up and then
dispose. Follow local ordinances and regulations for
disposal.
3. Insert new bag into collection tank and reinstall the
Dust Bag Holder and Separator Lid onto the tank.
3A5577C
LazerVac
1. When Vacuum Collection Bag has collected
approximately 45 lbs (20 kg) of dust, the bag should
be replaced. Momentarily pull down on the Vacuum
Release Handle, then turn the LazerVac off.
2. Pull down on the continuous bag to expose 6 - 12"
(15 - 30 cm) of new, unused bag.
3. Use a cable tie to tie off the top of the bag. Fasten
another cable tie 2" (5 cm) cable tie above the first
cable tie.
4. Wearing a respirator, cut the bag between the two
cable ties.
5. Dispose of the dust bag. Follow local ordinances
and regulations for disposal.
6. Pull down on the new bag attached to the vacuum
until the bottom of the bag rests on the bottom of the
vacuum cart. Ensure the bottom of the bag is tied off
firmly with the cable tie.
Operation
9