Advertisement
Battery installation
Depending on your chosen lipo 4 cell or 5 cell
will depend on where it is placed for your
required C of G. But once established it is a
good idea to install a small strap and velcro
to eliminate the movement of the battery.
SWITCH INSTALLATION
Install your receiver switch in the pre-cut slot in the side of the fuselage
COWLING
Once all holes have been cut and you are happy that there is no interference install cowling with bolts and
washers.
CANOPY
Install canopy to the hatch with Weston canopy glue or the self tappers provided.
RX BATTERY INSTALLATION(IC VERSION)
The battery installation will vary depending on engine used and C.G position require. A good starting point is
just behind the tank but if you want extreme 3D then slowly move the battery pack back to achieve your flight
characteristics. You can also use the rx tray to mount the rx battery as well
RX INSTALLATION
The Rx should be installed in foam and with all leads secured. A rx tray is provided and can also be used for
the rx battery.
SET UP
Use the nicad to adjust the C of G or lipo. The range for normal use is between and 145mm and up to 155mms
- from the leading edge of the wing.
CONTROL MOVEMENT SET UP MEASURED FROM INBOARD POINTS
Intermediate : ailerons 25mm up and down
elevator 25mm up and down
rudder 45 degrees side to side
Advanced:
ailerons Max throw
elevator Max throw
rudder Max throw
FLAPERONS
It is not necessary to have flaperons but these can give incredibly tight loop manoeuvres.
WARNING
On take off and landing beware not to apply full elevator as this may cause damage to the elevator in long
grass.
REMEMBER
Before flying check your model and do a thorough range check. Check all electrical connections are solid and
restrained and the receiver is in a padded area.
We trust you will have many happy hours of flying this model!!
Weston UK, 84-88 London Rd, Teynham, Sittingbourne, Kent Me9 9QH, England
Tel: +44(0)1795 521030 Fax or Tel: +44(0)1795 522020, E- mail alan@westonuk
If you have chosen the electric route you can easily
make a quick release canopy. Simply knock out the
capture nuts and use an inner and outer control rod
snake and a bit of fuel tubing at the ends.
EXPEDENTIAL
Intermediate: 15% - 30%
Expert 25% - 50%
www.westonuk.co.uk
Quick release canopy option
Advertisement
