Advertisement
Connecting the Router
Dispose of the cover and the wire in the pre-assembled cable clip, but keep the 2-pin connector for the power
supply side, and the 4-pin connector for the IR809 side.
Note
The IR809 should already have this 4-pin connector included, but if not, the one in the clip can be used.
Measure an appropriate length of wire for your installation and wire the 2 pin connector back onto the
PWR-IE50W-AC power source DC output as it was. Wire the opposite end of the wire to the IR809 4 pin
connector as instructed previously in the Wiring the DC Power and Alarm Connections section. Your finished
cabling will look like the connectors and wiring in the bottom of the following figure:
The connections should match up as in the following table:
Table 1: DC Source to IR809
PWR-IE50W-AC Pin
Number
1 (Bottom)
2 (Top)
PWR-IE50W-AC
Twisted Pair
Signal Name
WireDC Power
Connectivity
Power Out +
—> (Red in Figure)
Return Out -
—> (Black in
Figure)
Connecting the Router to the DC Source.
IR809 Pin Number
IR809 Signal Name
1 (DC In +)
DC Power Positive
Input
2 (DC In -)
DC Power Return
Connecting the Router
7
Advertisement
