Create A New Transaction Setup - Canon Oce VarioPrint 6000 MICR Series Operation Manual

Create a new transaction setup

Create a new transaction setup
Introduction
For transaction printing, transaction setups are required. Transaction setups contain specific
settings for specific transaction jobs. You can create setups in the Settings Editor.
NOTE
This section describes how to create a transaction setup from scratch. If you want to create a
transaction setup that is very similar to an existing setup, you can also create a copy and make
changes afterwards. In this case you must select the setup and click [Copy].
Procedure
1. Go to [Transaction printing] -> [Transaction setups].
2. Click the [Add] button.
A pop-up window appears.
3. Enter a name and description for the transaction setup, then click [OK].
4. Check the box next to the setup, then click [Open] to allow changes to the settings of the setup.
5. Depending on the type of setup you created, click [IPDS transaction setup] or [PCL transaction
setup].
NOTE
PCL is not available for all products. If you only have one license, the other PDL is not
available.
You can change the settings:
• By group (click the pencil at the right-hand side of the group settings).
• By item (click the pencil behind the individual settings).
After you changed the settings of a transaction setup, you must load the transaction setup to
make the setup changes active (see
28 Chapter 2 - Transaction printing
Activate a Transaction Setup on page
30).
Océ VarioPrint 6000 MICR line