Infeed Table; Outfeed Table - Carba-Tec CTJ-350 Instruction Manual

TABLE ADJUSTMENTS.

INFEED TABLE

C
The infeed table adjustment determines the depth of
cut, by raising or lowering the table in relation to the cut-
terhead.
A
The lower the infeed table the larger the cut. Loosen the
table lock handle Fig. 9 (A) at the back of the machine
and raise the table by pushing the handle up or down
Fig. 9 (B), the gauge in the front Fig. 9 (C) will tell you
B
exactly what your depth of cut is.

OUTFEED TABLE

The outfeed table should be level with the jointer knives
Fig. 9
at the highest point of their revolution. Once set to this
height it should not be adjusted,the depth of cut adjust-
ment comes from the infeed table only. If it is necessary
to adjust the outfeed table, loosen the lock handle lever
Fig. 10 (A) and raise or lower the handle Fig. 10 (B)
underneath the outfeed table. Don't forget to tighten the
locking handle Fig. 10 (A).
A
B
POSITIVE TABLE STOPS
Fig. 10
It is possible to preset the positive stops to maximum
and minimum depth of cut so it is not necessary to con-
sult the gauge each time you wish to change to these
settings Fig 11.
Fig. 11
5