The RTN PI-DC B10 is a full-outdoor PI. It uses DC power input and transmits GE electrical signals and -48 V power signals to the full-outdoor RTN 300 equipment through an outdoor network
cable.
A
Appearance and Ports
(1)
(1)
Cover of the PI
(2)
P&E cable (PI-side), pin assignments of the P&E
RJ45 connector and MGMT RJ45 connector
(3)
1:2 peeling indicator for P&E cables, DC cables,
and GE/NMS cables
(4) See "Safety Precautions".
GE electrical port (to FE/GE UNI equipment)
(5)
(6)
P&E port connected to a
P&E cable)
(7)
MGMT port connected to a P&E cable
(2)
(3)
(4)
(5) (6) (7) (8)
(9)
(10)
(13)
(12)
(11)
(8) NMS port connected to the NMS
(9)
DC power port connected to the power supply device)
DC input and P&E output status indicator
(10)
(11)
Plug
(12)
Cable hole
(13) Wire clip
B
Port Description
The GE electrical port is compatible with an FE electrical port and supports the MDI, MDI-X, and auto-
MDI/MDI-X modes.
Whether the P&E ports use MDI or MDI-X mode to transmit Ethernet service signals does not affect the
pin assignments for power signals.
Mounting ears
Pin assignments for power signals in the P&E ports