Advertisement
Attention! the manufacturer cannot be held responsible for, and does not cover in the
guarantee any damage resulting from bad or faulty connections.
The appliance is supplied without the connection cable; to install it, proceed in the following
way:
-Remove the back panel bye removing the screws that are around its perimeter as shown
in picture 1E
-Fit the connection cable through the cable channel, connect the conductor wires to the
corresponding terminals in the junction box as shown in picture 2E below and fix them into
place.
-Block the cable with the cable blocker, and reassemble the panel. The ground wire must
be longer than the others so that if the cable blocker should break for any reason, it will
disconnect after the hot wires.
N.B. The connection cable must have the following characteristics: it must be type H05RN-F
and must have an adequate section for the power of the appliance (see technical data table).
The installation of this appliance must conform with all applicable local codes.
In the absence of local codes, the installation must conform to the latest level of the
National Electric Code, ANSI/NFPA 70.
TECHNICAL ELECTRICAL DATA TABLE
Power
Power
Dimensions
Absorbition
MODEL
Power supply
max
supply
cm
max A
kW
cable
230Vac
PVS4EM
40 x 70 x 29h
21,74
5
3 x 2,5 mm²
50/60Hz
8
Officine Gullo
Advertisement
