Sealey Viking 4040TB Quick Start Manual

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear safety
instructions footwear
1. Safety
IMPORtaNt Safety WaRNING: aLWayS USe aXLe StaNDS
Ensure the jack is in sound condition and good working order. Take action for immediate repair or replacement
9
of damaged parts. Use genuine parts only. The use of improper parts may be dangerous and will invalidate
the warranty.
Locate the jack in a suitable, well lit working area.
9
Keep working area clean and tidy and free from unrelated materials.
9
Use jack on level and solid ground, preferably concrete.
9
Avoid tarmacadam as jack may sink in. Chock wheels of vehicle.
9
Ensure the vehicle handbrake is engaged, engine is switched off and transmission is in gear (or "PARK" if automatic).
9
Ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc., to allow for
9
vehicle tilting.
Ensure all non-essential persons keep a safe distance whilst the jack is in use.
9
Ensure there are no passengers in the vehicle.
9
Place jack under only those lifting points recommended by vehicle manufacturer (see vehicle handbook).
9
Check that the lifting point is stable and centred on the jack saddle.
9
Ensure the jack wheels are free to move and that there are no obstructions.
9
▲ DaNGeR: Use the jack for lifting only, NOt for supporting the lifted load.
Ensure there are no persons or obstructions beneath the vehicle before lowering.
9
Use suitable axle stands under the vehicle before proceeding with any task.
9
Use a qualified person to lubricate and maintain the jack.
9
NOte: Use Sealey quality hydraulic jack oil, Model No.s HJO500MLS / HJO5LS to top up or replace
the hydraulic fluid.
DO NOt operate the jack if damaged.
8
DO NOt allow untrained persons to operate the jack.
8
DO NOt exceed the rated capacity of the jack.
8
DO NOt allow the vehicle to move during lifting or lowering, or use the jack to move the vehicle.
8
DO NOt jack vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substances.
8
DO NOt work under the vehicle until appropriately rated axle stands have been correctly positioned.
8
DO NOt use the jack for purposes other than that for which it is intended.
8
DO NOt top up hydraulic system with brake fluid. Use hydraulic jack oil only.
8
DO NOt adjust the safety overload valve.
8
When not in use store jack, fully lowered, in a safe, dry, childproof area.
9
2. INtRODUctION
Heavy-duty 10mm gauge steel base design with large jacking pad for greater strength
and load stability. Universal joint release mechanism allows safer, more controlled
lowering of the jack. Rocket Lift feature brings lifting arm into contact with jacking
point with minimal pumps. Polyurethane wheels for smoother manoeuvrability and
helps prevent damage to workshop floor. Protective jack handle sleeve helps prevent
accidental damage to car bodywork when pumping the handle. Foot pedal for quick
approach of the lifting saddle to the vehicle in confined spaces. Includes removable
rubber saddle pad and built-in tool tray for fasteners and tools. 3 Year Warranty -
2nd & 3rd year subject to T's&C's and registration on website (www.sealey.co.uk).
3. SPecIfIcatION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4040tB
Capacity:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4tonne
Maximum Saddle Height: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 533mm
Minimum Saddle Height: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 100mm
Consumable Parts: . . . . . . . . . . . . . Replacement Rubber Jack Pad - JP17
© Jack Sealey Limited
VIkING tyRe Bay tROLLey Jack 4tONNe
LOW eNtRy W/ ROcket LIft
4040tB
ModEL no:
Original Language Version
TJL2
Apply
h ndbr ke
Use on h rd level floor
Chock
wheels
Do not
exceed
j ck c p city
Close
Lower R ise
Use suit ble
X2
xle st nds
w w w . s e l e y. c o . u k
4040TB | Issue 3 (3) 20/11/19