is necessary to verify its accuracy routinely, the user can
do the verification by means of SpO
be done by the local third party test house.
High-pressure sterilization cannot be used on the device.
Do not immerse the device in liquid.
It is recommended that the device should be kept in a dry
environment. Humidity may reduce the life of the device,
or even damage it.
6.2 Cleaning and Disinfecting Instruction
Surface-clean sensor with a soft cloth by wetting with a
solution such as 75% isopropyl alcohol, if low-level
disinfection is required, use a 1:10 bleach solution.
Then surface-clean with a cloth saturated with clean water
and dry with a clean, soft cloth.
Caution: Do not sterilize by irradiation steam, or ethylene
oxide.
Do not use the sensor if it is damaged.
14
simulator, or it can
2