Linx HumPRC Series Data Manual page 30

WAKEACK - ACK on Wake
Volatile Address = 0x59; Non-Volatile Address = 0x0E
When UART Acknowledge on Wake is enabled, the module sends an ACK
(0x06) character out of the CMD_DATA_OUT line after the module resets or
wakes from sleep. This indicates that the module is ready to accept data
and commands. A value of 0x01 enables this feature; 0x00 disables it. The
default value is 0x01. Figure 47 shows examples of the commands and
Figure 48 shows the available values.
HumPRC Series ACK on Wake
TM
Read Command
Header Size Escape Address
0x59
0xFF 0x02 0xFE
0x0E
Write Command
Header Size Address Value
0x59
0xFF 0x02 V
0x0E
Figure 47: HumPRC Series ACK on Wake Command and Response
TM
HumPRC Series ACK on Wake Register Settings
TM
V Mode
0x00 Disable ACK
0x01 Enable ACK
Figure 48: HumPRC TM Series ACK on Wake Register Settings
Read Response
ACK Address Value
0x59
0x06 V
0x0E
– –
54
UDESTID - User Destination Address
Volatile Address = 0x5A-0x5D; Non-Volatile Address = 0x0F-0x12
These registers contain the address of the destination module when User
Addressing mode or Extended User Addressing mode are enabled. User
Addressing mode uses bytes 0 and 1 to determine the destination address.
Extended User Addressing mode uses all four bytes. These registers are
automatically filled with the source address from a received message if
the received message address type matches the value in AUTOADDR.
Each register byte is read and written separately. Figure 49 shows the User
Destination ID registers.
HumPRC TM Series User Destination Address Registers
Volatile Non-Volatile
Name
Address Address
UDESTID3 0x5A 0x0F
UDESTID2 0x5B 0x10
UDESTID1 0x5C 0x11
UDESTID0 0x5D 0x12
Figure 49: HumPRC Series User Destination Address Registers
TM
Description
MSB of the extended destination address
Byte 2 of the extended destination address
Byte 1 of the extended destination address,
MSB of the short destination address
LSB of the extended destination address and
short destination address
– –
55