Id Remote Control - Philips Signage Solutions 55BDL3202H User Manual

55BDL3202H

2.3.2. ID Remote Control

Set the remote control ID if you intend to use this remote
control on several different displays.
Press [ID] button. The red LED blinks twice.
1. Press [ID SET] button for more than 1 second to enter the
ID Mode. The red LED lights up.
Press the [ID SET] button again will exit the ID Mode. The
red LED lights off.
Press the digit numbers [0] ~ [9] to select the display you
want to control.
For example: press [0] and [1] for display No.1, press [1] and
[1] for display No.11.
The numbers available are from [01] ~ [255].
2. Not pressing any button within 10 seconds will exit the
ID Mode.
3. If an error pressing of buttons other than the digits
occured, wait 1 second after the red LED lights off and
then lights up again, then press the correct digits again.
4. Press [ENTER] button to confirm. The red LED blinks
twice and then lights off.
NOTE:
• Press [NORMAL] button. The green LED blinks twice,
indicating the display is in normal operation.
• It is necessary to set up the ID number for each display
before selecting its ID number.
• Use " " (pause) key on the remote controller to freeze
the screen. Use " " (play) key on the remote controller
to unfreeze the screen.
• The "freeze" feature only can be adopted on "real" video
sources like VGA, AV, YPbPr, HDMI, DVI, DP.
• Any operation on the remote controller or video mode
change will unfreeze the screen.
8