Advertisement
Table of Contents
- 1 Setting up Your Recharging Station
- 2 Insert the New Rechargeable Battery
- 3 Insert the Battery Cover on Your Remote
- 4 Attach the Power Supply
- 5 Set the Charging Indicator on Your Recharger
- 6 Place the Remote on Your Recharging Station
- 7 Have Your Remote Recognize the Recharging Station
- 8 Recharging Station Lights
- Download this manual
Control4® Remote Recharging Station
Quick Setup
Recharge your remote anytime!
Now no more worries about your Control4 System Remote Control SR-150 or SR-250 quitting
in the middle of a TV program because the battery is dead. The Control4® Remote Recharging
Station ensures that you'll always have a fully-charged battery.
Setting Up Your Recharging Station
1
Remove the old batteries.
a
On the bottom of the remote,
pull the battery cover toward
you and lift it off of the
remote.
b
Pull out the batteries.
2
Insert the new rechargeable battery.
a
Insert the rechargeable battery
by sliding the small end
into the slot first.
b
Note the orientation of + and -
symbols for proper battery
insertion.
™
Advertisement
Table of Contents
Related Manuals for Control 4 C4-SRRS
Summary of Contents for Control 4 C4-SRRS
- Page 1 Control4® Remote Recharging Station Quick Setup Recharge your remote anytime! Now no more worries about your Control4 System Remote Control SR-150 or SR-250 quitting in the middle of a TV program because the battery is dead. The Control4® Remote Recharging Station ensures that you’ll always have a fully-charged battery.
- Page 2 ™ Insert the battery cover on your remote. Insert the remote’s battery cover into the remote’s slot and push down until the cover is flat against the remote. With the cover in a horizontal position, slide the cover into the slot until it snaps shut. Attach the power supply.
Need help?
Do you have a question about the C4-SRRS and is the answer not in the manual?
Questions and answers