Accessories; Guide Bar And Saw Chain Combinations; Recommended Cutting Equipment For Usa - Husqvarna 540i XP Operator's Manual

IPX4
Saw chain/guide bar
Recommended bar lengths, inch/cm
Usable cutting length, inch/cm
Type of drive sprocket/number of teeth
Maximum chain speed / (savE), m/s
Radio frequency data for Bluetooth
Frequency band, GHz
Output power, max dBm 0
Recommended cutting equipment for
USA
Following is a list of recommended cutting equipment for
Husqvarna 540i XP and . This model equipped with
either of the listed guide bar and saw chain
combination(s), fulfills the requirements according to UL
60745-1 and UL 60745-2-13.
Chainsaw models Husqvarna 540i XP and met the
kickback performance requirements of UL 60745-2-13
when tested with the combinations of bars and saw
chains listed below. The saw chain Husqvarna H38 is
also classified as a low kickback saw chain since is met
the requirements for low kickback saw chain outlined in
UL 60745-2-13. We recommend to use only the listed
combinations of bars and saw chains for chainsaw
models Husqvarna 540i XP and . Other chainsaw
models may not meet the kickback requirements when
equipped with the listed bar and saw chain
combinations.

Guide bar and saw chain combinations

Following is a list of recommended cutting equipment for
Husqvarna 540i XP and . The listed combination(s) of
Guide bar
Length, in Chain pitch, in
12 3/8 mini
14
16
1065 - 002 - 13.05.2020
®

Accessories

Gauge, in Max. nose ra-
dius
0.050 9T
540i XP
Yes
10-14/25-35
9-13/23-33
3/8"/6 (S93G), m0.325"/7 (SP21G)
24 (18)
2.4-2.4835
0
powerhead, guide bar and saw chain meet all
requirements outlined in Canadian Standards
Association Z62.1-11 (Chain saws) and Z62.3-11 (Chain
Saw Kickback).
Furthermore the saw chain Husqvarna H38 is evaluated
and listed as a Type C Low Kickback Saw chain
according to the provisions in Z62.3-11.
Kickback information
The guide bar nose radius is determined by either the
maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius,
you may use a guide bar with smaller nose radius than
in our list. For guide bars of the same length, all
sprocket-nose guide bars of the same pitch and having
the same number of sprocket teeth may be considered
to have equivalent kickback energy.
The following cutting equipment is approved for the
models Husqvarna 540i XP.
Saw chain
Type
Husqvarna
S93G
Length, drive Low kickback
links (no.)
45 Yes
52
56
35