TRENDnet TEW-630APB Quick Installation Manual page 9

300mbps wireless n access point

Hide thumbs Also See for TEW-630APB:

Q4:

After I successfully configured the Access Point to meet my network settings,

I can not connect to my network using wireless computers.

A4:

If you have a DHCP server in your network, you need to go into TCP/IP

settings again and re-select "Obtain an IP address automatically" to allow the PC

to regain an IP address from your DHCP server.

Q5:

All the settings are correct, but I can not make a wireless connection to the

Access Point.

A5:

First, double check that the WLAN light on the Access Point is lit. Second,

power cycle the Access Point. Unplug the power to the Access Point. Wait 15

seconds, then plug the power back in. Third, contact the manufacturer of your

wireless network adapter. Make sure the wireless network adapter is configured

with the proper SSID. The default SSID of the Access Point is TRENDnet. If you

have enabled any encryption on the Access Point, make sure to configure the

wireless network adapter with the same Pre-shared key.

If you still encounter problems or have any questions regarding the TEW-630APB,

please contact TRENDnet's Technical Support Department.

Table of Contents