Connecting Example: Av Equipment - Panasonic PT-VMZ50 Operating Instructions Manual

Connecting example: AV equipment

D-sub / component
conversion cable
Attention
f Always use one of the following when connecting a VCR.
- A VCR with built-in time base corrector (TBC).
- A time base corrector (TBC) between the projector and the VCR.
f If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector (TBC) between the
projector and the external devices.
Note
f For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. In addition, when 4K video signal is to be input,
please use HDMI cable that is compatible with 4K video signal. Images may be disrupted or may not be projected when a video signal
exceeding the supported transmission speed of the HDMI cable is input.
f The <HDMI 1 IN> terminal /<HDMI 2 IN> terminal can be connected to an external device with the DVI-D terminal by using an HDMI/DVI
conversion cable. However, this may not function properly for some external devices, and image may not be projected.
f This projector does not support the VIERA Link (HDMI).
f To output the signal input to the <COMPUTER 1 IN> terminal from the <COMPUTER 2 IN/1 OUT> terminal, set the [PROJECTOR SETUP] menu
→ [COMPUTER2 SELECT] to [COMPUTER 1 OUT].
f To output audio, properly set the [PROJECTOR SETUP] menu → [AUDIO SETTING] → [AUDIO IN SELECT].
f When the <VARIABLE AUDIO OUT> terminal is connected with cable, the sound will not be output from the built-in speaker.
Chapter 2 Getting Started - Connecting
DVD player
Video deck(TBC built-in)
Blu-ray disc player with HDMI terminal
Audio equipment
ENGLISH - 37