Download Print this page

JBA Cat4ward 2010S Installation Instructions And Warranty Information

Headers for toyota tundra 4.7l v-8

Installation Instructions

and Warranty Information

for JBA Headers

For ʻ00-ʻ03 Toyota

Tundra 4.7L V-8

2 & 4 Wheel Drive.

Part Number 2010S

This picture is a representation of the product and may not be the actual application photo for your vehicle.

Read all instructions carefully before attempting installation.

Rev 7/01

Table of Contents

Need help?

Do you have a question about the Cat4ward 2010S and is the answer not in the manual?

Page 1 Installation Instructions and Warranty Information for JBA Headers For ʻ00-ʻ03 Toyota Tundra 4.7L V-8 2 & 4 Wheel Drive. Part Number 2010S This picture is a representation of the product and may not be the actual application photo for your vehicle.
Page 2 Use caution not to drop or damage the sensor, they are fragile. Now you are going to install the new JBA Header, but first there is some preparation of the hardware required. Apply antiseize to the threads of the new fasteners. Install the new JBA Header using the supplied gasket and fasteners.
Page 3 As you did on the passenger side, prepare the hardware before installing the driver side header. Apply antiseize to the threads of the new fasteners. Install the new JBA Header using the supplied gasket and fasteners. Torque to 23 ft. lbs. Re-install the dipstick tube.
Page 4 AEP, at its option, will repair or replace any product found to be defective in materials or workmanship. Failure of any JBA product which fails while on the originally installed vehicle, will entitle the pur- chaser to repair, replacement, or pro rata credit according to the following chart:...