JBA 1674S Installation Instructions

Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 • FAX 909.599.6424

Installation Instructions

and Warranty Information

JBA Headers for 1997-2007 Ford Ranger,

Explorer, and Sport Trac with 4.0L SOHC V-6

Part# 1674S (Passenger Side EGR)

Part# 1674S-1 (Driver Side EGR)

Part# 1674S-2

For 1997-2006 Vehicles:

The product accompanying this document has been granted a California Air Resources Board (CARB)

exemption, an "E.O." number, or is a direct or consolidated replacement part. It is 50-state legal, per the

manufacturer's application guide.

These headers retain all O.E.M. emissions equipment and are covered under the C.A.R.B. E.O. #D-216-29

Included in this kit you will find a label that is required to aid in passing the California smog check program.

For 2007 Vehicles:

WARNING: The product accompanying this document is legal only for off-highway use (except in California

or states that have adopted California emission standards), racing use or for use on pre-emission-controlled

motor vehicles/motor vehicle engines (pre-1966 domestic vehicles certified to California standards, pre-1968

domestic vehicles certified to federal standards and all pre-1968 foreign vehicles), per the manufacturer's

application guide.

Rev. 06/11

Table of Contents

Do you have a question about the 1674S and is the answer not in the manual?

Page 1: Installation Instructions
Corporate Office: PerTronix Inc. 440 E. Arrow Highway, San Dimas, California 91773 * Phone 909.599.5955 • FAX 909.599.6424 Installation Instructions and Warranty Information JBA Headers for 1997-2007 Ford Ranger, Explorer, and Sport Trac with 4.0L SOHC V-6   Part# 1674S (Passenger Side EGR)
Page 2 JBA uses sealing beads on all its headers. We have found that when installed correctly, the raised bead around each port increases the pressure exerted on the gasket directly adjacent to the port and effectively prevents leak- ing gaskets.
Page 3 (use P/N 1674-1) or on the rear of the passenger side manifold (use P/N 1674). 4. For P/N 1674S: From above, loosen the EGR tube at the rear of the passenger side manifold. For P/N 1674S-1: From above, loosen the EGR tube at the front of the driver side manifold.
Page 4: Limited One Year Warranty
This sticker must be installed in an underhood location that is readily visible. LIMITED ONE YEAR WARRANTY All JBA HEADERS and exhaust products are guaranteed, to the original purchas- er, to be free of defects in materials and workmanship for one year. This warranty...

1674s-11674s-2