Victrola ITSBL-547 Instruction Manual

Victrola ITSBL-547 Instruction Manual

Groovy lamp

Advertisement

Quick Links

Groovy Lamp
Bluetooth Speaker
Model: ITSBL-547
Instruction Manual
PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE
AND KEEP IT FOR FUTURE REFERENCE.

Advertisement

Table of Contents
loading

Summary of Contents for Victrola ITSBL-547

  • Page 1 Groovy Lamp Bluetooth Speaker Model: ITSBL-547 Instruction Manual PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE AND KEEP IT FOR FUTURE REFERENCE.
  • Page 2 IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER SERVICEABLE PART INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lighting flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage”...
  • Page 3 5. Do not use this apparatus near water - The appliance should not be used near water; for example, near a bath tub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool. 6. Clean only with dry cloth - The appliance should be cleaned only as recommended by the manufacturer.
  • Page 4 14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
  • Page 5: Care And Operation

    CARE AND OPERATION During the initial warm up of the lamp, the heat coil in the base may tend to stand on the end or float to the top of the lamp. If this happens, keep your lamp operational for 4 or more hours to allow the waxy material to melt completely.
  • Page 6: Important Safety Instructions

    CAUTION: � Do not operate the lamp wireless speaker with any other bulb except for the one provided by this manufacturer’s customer service. � Do not leave lamp unattended. Do not run the lamp while sleeping, as this is novelty item and it is not intended to be used as night light. �...
  • Page 7: Product Overview

    PRODUCT OVERVIEW 1 Vessel Cap 2 Glass Vessel 3 Speaker 4 Speaker On ( ) / Off / Speaker + Light ( 5 3.5mm Aux-In 6 AC Power Plug Front Right side Back NOTE: BE CAREFUL! - THE GLASS VESSEL IS FRAGILE. - THE GLASS VESSEL, AND SPEAKER BASE ARE BOTH VERY HOT WHEN IN USE AND SHORTLY AFTER USE.
  • Page 8: Bluetooth Operation

    3. Turn on the Bluetooth on your external Bluetooth device and select the pairing name “ITSBL-547” from your device’s Bluetooth settings. 4. The speaker will sound an audible tone and the Bluetooth indicator will stay lit after successful connection.
  • Page 9: Troubleshooting Guide

    TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION Switch the power switch to Power switch is in “OFF” Can’t Power On position. “ON” position. No Sound or Volume level of the paired Increase the volume of Weak Sound device is too low. paired device.
  • Page 10: Specifications

    SPECIFICATIONS POWER SOURCE ..............AC 120V~60Hz AUDIO OUTPUT ..................1X3W BLUETOOTH RANGE ............... 33ft (10m) BULB LIFE ................... 2000hrs BULB FLUX ....................90 lm BULB POWER .................... 30W BULB TYPE ....R39 Reflector Spotlight E17 120V/30W Standard Bulb Please note: As a result of continual improvements, the design and specifications of this product are subject to change without notice.
  • Page 11: Warranty

    FCC STATEMENT: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
  • Page 12 God or attempted repair by an unauthorized service agent. To obtain service, the purchaser MUST present an original sales receipt / proof of purchase. Please contact us at www.victrola.com to request an RMA (Return Material Authorization) number to return products for service or replacement.

Table of Contents