Care And Maintenance; Replacing The Ear Pads; Cleaning The Dust Protection - T+A SOLITAIRE P User Manual

Care and maintenance

Replacing the ear pads

• To remove the ear pad, grab underneath the pad
from the inside and lift it off as shown in the picture.
• If necessary, push against the pad from the outside
with your thumb to push the fastening ring inside
the pad out of the groove.
• To fasten the ear pads, insert the fastening ring
integrated in the pad into the groove on one side.
• Then insert the fastening ring into the groove all the
way around.

Cleaning the dust protection

• The red dust protection in front of the driver mem-
branes can be removed for cleaning.
• First remove the ear pad as described above.
• Remove the dust protection.
• Clean the dust protection with warm, clear water and
let it dry completely in the air.
• Refit the dust protection so that the edge does not
protrude over the housing of the earcup.
• Attach the ear pad.
Never use the headphones without the dust protection.
j
The dust protection will prevent any damage to the
diaphragm by foreign matter. Take care that no foreign
matter gets inside through the openings of the earcups.
Dust protection
Ear pad
Fastening ring
Groove
25