Table of Contents
Advertisement
Screen House and accessories full instructions
Erecting the screen house
• Remove the screen house from the carry bag and place onto the ground.
• Stand the screen house up with the large black centre hub placed on the ground and allow the
legs to open and lie on the ground. Ensure that the roof (green in colour) is facing upwards.
• Grasp the pull loop attached to the centre of one of the sidewalls. Pull upwards and outwards on
the loop until the sidewall pops open.
• Walk around the screen house and repeat this with each sidewall until all the sides are popped
out. At this point the screen house will stand up and the roof will be pointing downwards.
• Walk inside the screen and place your hand on the centre hub of the roof. Push this up until the
roof pops open. You may find it easier to have someone hold the screen house down whilst you
do this step. If not then simply hold one of the roof poles in place with one hand and push up on
the centre hub with your other hand.
• Once the roof has been popped take a door pole out of the bag and unfold. Once unfolded place
into the two pockets at the top and bottom left corners of the entrance. Once in place secure with
the Velcro tabs. Repeat the process on the other door pole on the right hand side. NOTE : On a
Screen House 6 Pro there are two doorways, so this has to be done twice.
• Failure to do the above steps could lead to the roof of the screen house being blown down during
high winds. The screen house is now fully erected, but we recommend that the screen house be
pegged at all times.
• Peg each corner of the screen house inside using the pegging eyelets and pegs that are included
in the screen house (you can use your own pegs if you prefer).
• Once all the corners have been pegged, peg the centre of each sidewall using the pegging eyelet
attached to the bottom of each sidewall.
• Attach the storm straps (if not already attached) to the screen house via the stainless steel loop
in the centre of the sidewall. Peg the other end of the storm strap into the ground and then tighten
the strap. DO NOT over tighten the strap. The strap should be tight enough to hold the sidewall in
place, it should not pull the sidewall towards the ground.
Taking the screen house down
• The screen house should not be taken down in high winds as it could cause damage when the
storm straps and pegs are removed. If you are taking it down in high winds you must take extra
care and always have more than one person present to help secure the screen house once the
straps and pegs have been removed.
• Slacken the storm strap, remove the peg from the ground and un-clip from the screen house.
Repeat on each side of the screen house.
• Remove all pegs from the corners and sidewalls.
• Remove the two door poles by unfastening the velcro tabs and removing the poles from the
pockets.
• Walk to the centre of the screen house and using the pull loop attached to the roof pull the roof
down until it relaxes fully. Take care not to pull the roof down on top of yourself.
• Walk outside of the screen house and push the centre of the sidewall in until it springs in and
collapses. You may find it easier to hold the top left corner with one hand and push the centre in
with the other.
• Repeat step 5 on every side until the entire screen house has collapsed.
• Once the screen house is laying on the ground, roll the screen house up. ENSURE that the frame
is not twisted when doing this.
• Carefully place the screen house into the carry bag.
8
Template version: 3
Advertisement
Table of Contents
