Table of Contents
Advertisement
Screen House and accessories full instructions
Optional Extras : Side Walls
You can purchase additional side wall blinds for your screen house (not Pro models as they have
them built in), wich attach to the outside of your screen house and give you extra privacy, cover and
protection.
Attaching the optional side wall blinds to the Screen House
• Remove the sidewall(s) from the packaging.
• If the storm strap is attached and pegged on the screen house, remove the storm strap before
attaching the sidewall by un-clipping it.
• Unfold the sidewall. Attach the hook found in each corner of the sidewall to the D ring located on
the screen house at each corner of the side.
• NOTE: The panels are not square so ensure that the sewn line runs horizontally along the bottom
when attaching the sidewall to the screen house.
• When the sidewall is attached to the side carefully pull the pull loop on the screen house though
the centre hole in the sidewall. Once done you can re-attach the storm strap to the pull loop.
• Once the above is down ensure that the velcro tabs are attached all the way around the sidewall.
The sidewall should go underneath the roof flap (the roof flap is only present on a screen house
2016 onwards) to ensure the best possible water run off.
• Repeat for each sidewall you wish to attach.
Removing optional side wall blinds from the Screen House
• If the storm strap is attached and pegged on the screen house, remove the storm strap before
attaching the sidewall by un-clipping it.
• Detach the velcro straps from around the side of the sidewall.
• Un-clip the clip from the D ring located at each corner of the sidewall.
• Remove the sidewall from the screen house and fold and pack away.
Optional Extras : Front Canopy (Pro only)
You can purchase a front canopy for your Screen House Pro, which gives you a covered canopy
area to the front of the screen house. The canopy goes on the front accessory zip on your Screen
House Pro. The Screen House 4 Pro only has one accessory zip, but the Screen House 6 Pro has
two (one front, one rear). The front accessory zip is the one that has the printed logo above it.
• Take the canopy out of the bag and locate the zip(s) on the canopy. There are two zips on the
canopy, one for use with a screen house 4 pro and one for use with a screen house 6 pro. The
screen house 4 zip is the longer of the two.
• Using the correct Zip the canopy onto the accessory zip on the screen house pro, starting from
the bottom left and moving around to the bottom right.
• Put the included pole together and feed it though the sleeve at the front of the canopy. There is
a pin at the bottom of the canvas where the pole is inserted onto. This keeps the pole in place.
• There is also a pegging strap along the bottom of the canopy. This is simply an aid to pegging
the canopy. It helps ensure you get the canopy pegged just right, but it is only optional, you do not
have to use it, if you do not wish to.
• Once the pole is in place, pull the canopy away from the Screen House until the roof becomes
tight and peg the storm straps and the bottom of the pole ends.
10
Template version: 3
Advertisement
Table of Contents
