Initial Startup Of The Sinterit Sandblaster After Delivery - SINTERIT SANDBLASTER User Manual

5. Initial startup of the Sinterit SANDBLASTER after delivery

1. Remove all the solid protective packaging.
2. Gently pull out the SANDBLASTER and accessories.
3. Remove the bubble wrap and place the machine on a
stable surface.
Screw the Adjustable mounting feet
4.
the SANDBLASTER's base and place the machine at
its working destination.
5. Screw the Pneumatic nipple
12
nipple in the SANDBLASTER (side with thead and
Teflon tape).
6. Connect the T-type push-in pneumatic fitting
the Pneumatic nipple
L
Pneumatic tubings
7. Plug the Control pedal's pneumatic tubings (red and
I
blue) and the Control pedal
13
pedal input fitting
sure that the pneumatic tubings are well connected
(suitable colours under the SANDBLASTER).
8. Plug the Air blow gun
compressor into the right tubing
is not included in the Sinterit SANDBLASTER set).
9. Unlock the SANDBLASTER lid
10
and open it. Remove the transport protective
elements inside the machine.
10. Check the fitting and tightness of the Protective
2
Rubber Gloves , the Nozzle
11. Put on the Protective Dust Mask and Protective
Glasses (e.g. you
PROTECTION" set included with Lisa printers).
12. Pick up the two parts of the grille at the bottom of the
SANDBLASTER's chamber
for the hole marked with an arrow. It is located on the
left side of the SANDBLASTER chamber. Insert your
finger into the hole, pick up the grille and pull it out of
the SANDBLASTER. Gently add the Abrasive Material
N
(add not more than 4.53 [kg]/ 10 [lbs]). Insert the
grille back into its place.
13. Remove all the stickers inside the chamber
first use.
14. Check that the PE protective foil
SANDBLASTER viewing window
on default), clean it with a soft cloth if necessary.
15. Close the SANDBLASTER lid
16. Plug the Power supply
7
Power socket . Plug it into the electric outlet.
17. Turn on the SANDBLASTER with the Power switch
18. Check that the LED light
19. Turn on the compressor. Check all pneumatic tubings and joints for leaks.
20. If there are any leaks, tighten the Pneumatic nipple
E
(4 pieces) to
F
to the Pneumatic inlet
H
F
and then, on both sides, the
M
, .
J
into the Control
in the SANDBLASTER. Make
G L
into the left tubing and the
M
(the compressor
6
with the lid lock
5
and the Air filter
can use the „PERSONAL
11
. To raise the grille, look
11
before
D
of the
6
is installed (it is
6
firmly.
A
into the SANDBLASTER
4
is working.
BLUE
RED
to
Image 4. Correct connection of the Control pedal pneumatic
tubings to the Sinterit SANDBLASTER
3
.
Image 5. Correct connection of all tubings and cables
in the Sinterit SANDBLASTER.
8
.
F
to the SANDBLASTER with the included wrench
(blue and red).
K
Sinterit SANDBLASTER User Manual | 7
.