General Legal Information; Disclaimer; Trademarks - SINTERIT SANDBLASTER User Manual

A flow of abrasive is to week and the
Nozzle has been cleaned.
Any other problems not described in this manual should be reported to Sinterit Support by contacting through:
• email: contact@sinterit.com, support@sinterit.com
• www: sinterit.com/support-page/
• phone: +48 570 702 886.

9. General legal information

Where this manual refers to Sinterit or the Company, this means Sinterit sp. z o.o. with its legal seat in Krakow,
registered by the District Court for Kraków-Śródmieście in Krakow, XI Commercial Division of the National Court
Register under number: 535095, NIP (tax number): 6793106416, with the share capital for a date of publication
of this manual of PLN 83,750 (say: eighty-three thousand seven hundred fifty).
This document contains material protected under copyright and industrial property laws. This means that the document
may not be, including but not limited to, reproduced or modified without the consent of Sinterit.
This manual serves to assist in the correct use of the device, perform basic maintenance and, if necessary,
to solve simple problems, allowing to maintain the device in a good condition.
This manual contains content exclusively for the provision of information and the use by individuals professionally
trained and engaged in the operation and maintenance of the equipment described below.
The information contained in this document is intended for use only with the product called Sinterit Sandblaster.
Due to the constant development of Sinterit's products the information contained in this manual, specifications and
markings are subject to change without notice.

10. Disclaimer

Sinterit is not responsible for any use of this information in relation to other products.
Sinterit is not liable for any damages, including but not limited to losses or lost profits, resulting from the use
of any materials (consumables) other than those provided to the purchaser by Sinterit.
Sinterit is not liable to the purchaser of the product or any third party for any damages, including but not limited to
losses or lost profits resulting from improper use of the product, particularly not in accordance with this manual, or
modifications or repairs unauthorised by Sinterit or improper maintenance.
Although every effort has been taken to provide accurate information about the product, Sinterit assumes no responsibility
for any incorrect information or omission. Sinterit reserves the right to correct any errors and disclaims any liability in
situations resulting from these errors.
Further limitations or exclusions of Sinterit`s liability may result from the applicable laws or agreements entered into with
the purchaser of the products.

11. Trademarks

SINTERIT name and logo, as well as Sinterit SANDBLASTER name, are registered trademarks of the Company (or
necessary motions have been filled to register the trademarks).
10 | Sinterit SANDBLASTER User Manual
1.
Remove the Nozzle, close the
SANDBLASTER and start the
abrasive flow.
2.
This process should remove
every object that is in the air
flowing duct.
3.
Install the Nozzle back.