Table of Contents
Advertisement
3 Installing Bays
(Optional) Removing side panels
3a
Do this procedure only when your storage system is configured with system bays and disk bays.
In this case, there is one system bay and one disk bay placed beside each other. You need to
remove the system bay side panel against the disk bay and the disk bay side panel against the
system bay before installation so that SAS cables can be routed between the two bays.
To remove a side panel, do as follows:
1. Insert the key (locks on the front and rear doors and the side panels use the same key) delivered with the
bay to any of the two keyholes on the side panel and turn the key clockwise to open the lock, and then do
the same in the other keyhole.
2. Pull the handle below the keyhole to detach the side panel's upper part from the bay.
3. Remove the side panel from the bay.
6
6
Advertisement
Table of Contents
